Replacement spares for Suzuki

• 12 Volt and 6 Volt
• Lead acid, AGM and Gel batteries
• Quick mode change button on front face
• 1 Amp
• Battery Range 1.3-60Ah
• Cable Length 1m (To quick connect plug), 1.1m (Including clamps/eyelet cable)
• Trickle charger
• Quick release plug with cover
• Wall plug compact design
• Weight 0.58Kg

• 12 Volt and 6 Volt
• Lead acid, AGM, Gel and Lithium batteries
• Quick mode change button on front face
• 2 Amp
• Battery Range 1.3-60Ah
• Cable Length 1m (To quick connect plug), 1.1m (Including clamps/eyelet cable)
• Trickle charger
• Quick release plug with cover
• Wall plug compact design
• Weight 0.58Kg

Kit contains 4 parts:
2 Seals
2 Tapered Bearings
Bearings are 55x30x17
WARNING: Seals are unsuitable for
YZF R6 and YZF R1 Bikes

Kit For 2 Calipers Contains:

• 8 wiper seals
• 8 dust seals
• 4 caliper joint seals
• 2 stainless steel bleed nipples
• 2 bleed nipple covers
• 4 copper washers
• 1 sachet of red rubber grease

Kit For Single Caliper Contains:

• 1 wiper seal
• 1 dust seal
• 2 shaft boots
• 1 stainless steel bleed nipple
• 1 bleed nipple cover
• 2 copper washers
• 1 sachet of red rubber grease

89mm inner diameter
220mm outer diameter
110mm between bolt hole centres
10.5mm counter-bored bolt holes
5mm thick

For Hoses requiring special fittings the banjos can only be supplied in silver.
Made to order, usually 24 hours to manufacture
Two lines in a Kit, Supplied with black heat shrink over the end of the hose
The longer line goes from the Master Cylinder to one of the Calipers,
then Connects both lines using the Double Banjo Bolt and washers on the Caliper.
Run the shorter line over the Mudguard to reach the other Caliper.

For Hoses requiring special fittings the banjos can only be supplied in silver.
Made to order usually 24 hours to manufacture
Two lines in a Kit
Supplied with black heat shrink over the end of the hose

For Hoses requiring special fittings the banjos can only be supplied in silver.
Made to order, usually 24 hours to manufacture
One line in a kit
Supplied with black heat shrink over the end of the Hose

SCOA412-ASDH-PL.
Warning : DID do not recommend the cutting and Riveting of Cam Chain at home
as incorrect fitment could result in engine seizure and resulting injury.

Genuine part does NOT come with O ring

**** PLEASE READ THE INSTRUCTIONS FIRST *****
520 Chain to 530 Chain soft rivet link only,
old rivet heads need to be ground off
with an angle grinder before they can be extracted.

Motul Chain Clean uses no chlorine and features an extremely powerful de-greasing agent
which removes crusted residues that increase wear from: dust, sand, earth and oil.
If the chain is very dirty, clean with a non-abrasive brush and repeat as often as necessary.
Leave to dry for 5 minutes, then lubricate with Motul Chain Lube or Chain Paste.
Always spray the chain with Motul Chain Clean before lubricating.
Compatible with all types of chains: standard or O'ring, X'ring and Z'ring.

A smooth yellow lubricant, Motul Chain Lube Off Road is highly recommended for off-road use.
This specially formulated chain lubricant does not contain sticky additives
and is suitable for trails and motocrosses.
Motul Chain Lube Off Road protects chains from grease and dust build-up.
Suitable for all chains with or without O-ring seals.

A colourless water and rust resistant adhesive spray that coats motorcycle chains
even at high speeds, reducing high speed splatter.
Especially recommended for very fast motorcycles,
Chain Lube Road reduces friction and increases chain durability.